One of the most important process parameters of annealing is the highest heating temperature (annealing temperature). The annealing heating temperature of most alloys is selected based on the phase diagram of the alloy series. The annealing temperature of various copper sleeves and copper alloys, depending on the specific annealing purpose, is a certain temperature above Ac3 and above or below Ac1 of each copper species. The annealing temperature of various non-ferrous alloys is a temperature below the solidus temperature and above or below the solid solubility temperature of the alloy.
Recrystallization annealing is applied to alloys that undergo solid phase transformation (recrystallization) during balanced heating and cooling. The annealing temperature is a temperature above or within the phase transition temperature range of each alloy. Both heating and cooling are slow. The alloy undergoes a phase change and recrystallization during the heating and cooling process, so it is called recrystallization annealing, often referred to as annealing for short.
Homogenization annealing is also called diffusion annealing. An annealing method applied to ingots or castings of steel and non-ferrous alloys (such as tin bronze, silicon bronze, aluminum bronze, cupronickel, magnesium alloy, etc.). The ingot or casting is heated to a higher temperature below the solidus temperature of each alloy, kept for a long time, and then slowly cooled down. Homogenization annealing is to make the elements in the alloy diffuse in a solid state to reduce the inhomogeneity of chemical composition (segregation), mainly to reduce the inhomogeneity of chemical composition in the grain scale (intragranular segregation or dendrite segregation).
The homogenization annealing temperature is so high to accelerate the diffusion of alloy elements and shorten the holding time as much as possible. The homogenization annealing temperature of the copper sleeve is much higher than Ac3, usually 1050~1200℃. The temperature for homogenization annealing of non-ferrous alloy ingots is generally "0.95×solidus temperature (K)". Homogenization annealing has a high heat consumption due to the high heating temperature and long holding time.
After the copper parts are annealed and cooled, a uniform thin transparent non-stripping film can be produced on the metal surface, so that copper and copper alloys have good anti-tarnishing and anti-oxidation capabilities. It is widely used in the copper sleeve and copper alloy industry, such as the annealing process of copper sleeves, copper wires, copper clad aluminum, copper clad steel, bare copper flat wires, and electromagnetic wires by copper manufacturers.
www.cn-czpufa.com
